There are many types of steam shower units on the store today, but they all have one thing in coarse - ease of installation. All of them wish a level base in order for the unit to be stable and to ensure proper drainage for the water. The front of the unit, which is typically the door, is the first wall you should join together to the base. The unit comes with the self-tapping screws or bolts that you will need for this task. Once you have this wall in place, you can go ahead and assemble the other walls and attach them to the base.
Detailed instructions come with all steam shower units. Even if you are a person that doesn't like to read directions, these directions are foremost because dissimilar manufacturers have dissimilar routes for installing the varied units. You cannot assume that because you helped your neighbor install such a unit that the one you have will involve the same process. In some models, you have to apply a layer of silicone colse to the edges to seal the corners, while other models have rubber seals, which are already in place.
Shower Wall
Once you install the walls of steam shower units, then you can put the top of the unit in place. Up until this point you may have noticed that the unit was not as stable as you would like, but once you have the top in place, you will be pleased with its sturdiness. Once you apply the sealant, if it is required, you should tighten all the nuts and bolts and join together all the colored wires.
When installing steam shower units in homes where the plumbing is already in place, you won't have much difficulty connecting the water pipes. The units do come with flexible hoses and water lines, but you do need to make the connections in the wall where you are installing the unit. The drain has to be installed underneath the unit. You may have to make some modifications to the plumbing when remodeling a bathroom that you have enlarged in order to make room for the shower and the steam shower enclosure.
Steam room units must have their own dedicated electrical circuit or if this is not possible, you need to have the bathroom on its own circuit. Check the ground fault circuit interrupter to make sure that it is functioning properly. If it is not you will have problems when you start to operate the steam unit and you will have to make changes in the wiring to protect against electrical shock.
In addition to following the detailed directions for the factory of steam shower units, you so have to look at how your bathroom is ventilated. Ventilation is very foremost to avoid a buildup of excess moisture from a steam shower or hot tub that could cause dampness, which in turn could lead to mold, mildew and other structural damage. A vent similar to the type you use for your clothes dryer is enough for this purpose.
Another similarity in all steam shower units is that you should run the water in them for at least five minutes before you use them for the first time. By doing this simple chore, you can be sure that the water running straight through the hoses and pipes that come with the units takes out any residue of chemicals that could remain.
How to install Steam Shower Units
No comments:
Post a Comment